With two Little Smokies running around it’s hard to find time for the selfish contemplation that is brewing and barbecuing. Brewing takes a good 5 hours from the time I get the supplies out untill everything is cleaned up. Cooking up some pulled pork takes about 15 hours, not to mention the prep time the night before. True, I don’t have to sit next to the smoker for 15 hours, but it’s always on my mind. In my search to be more zen with my barbecuing I’ve found a couple “helpers” to keep my alter ego of Super-Stressed-Out-Action-Man at bay.
First off, for the past couple years I have been using terracotta flower pot bases and tin-foil in my water pan instead of water. This is definitely nothing new or groundbreaking, but I finally got around to trying it and now I wouldn’t have it any other way. The whole point of using a water pan is to help keep a steady temperature in your smoker by increasing the thermal mass. Unfortunately water evaporates and needs to be topped up. Then there is the mess of dirty water with all the fat drippings from your meat. Now I just peel away the top sheet of aluminium foil and throw it away.
That alone is not enough to keep the fire under control. Luckily I now have the PartyQ from BBQ Guru. The PartyQ is one of the cheaper Automatic Temperature Controllers on the market. It isn’t the most feature rich ATC but I was looking for a simple set it and forget it solution. I don’t need to see a temperature log on my smartphone. It also runs off of 4 AA batteries, which is good since the nearest electrical socket is far from my smoker. I did read some negative reviews of the PartyQ but those seemed to be coming from people who were trying to use the PartyQ to bring their fire up to temperature. This can take a while, lead to a massive overshoot in temp, and kill your batteries. I have had no problems so far and the temperature in my smoker stays rocksteady. The only time I see a change is when I open the lid to mop the meat, but this is quickly taken care of without any action on my part. The PartyQ has been a dream and if you follow a couple of basic rules then it is a very powerful tool.
The PartyQ has one probe with an alligator clip on it. The clip can be pulled off so that the probe fits through the BBQ guru probe eyelets I installed years ago for my wireless Maverick ET-73. Since I have the Maverick I didn’t need to get an ATC which has a food probe too, and I can still monitor my smoker and meat temps from inside the house.
How I use the PartyQ:
- Install Maverick ET-73 and PartyQ
- Start the fire with the Minion Method and assemble the WSM
- Bottom vents 80% open (Except for where the PartyQ is attached of course. Follow instruction manual for that)
- When smoker is close to target temp, close bottom vents & switch on PartyQ (if the temp overshoots it can take a while before it comes back down)
- When the cook is done pull off the PartyQ and insert the kill plug.
now here is a very boring video of the PartyQ in Action